2. There is a leak in the brake system, the system can not maintain pressure, resulting in poor braking effect. 3. The free clearance of the brake caliper is too large, so that the gap to be compensated during braking is large, so that the brake lags behind and the braking effect is poor. 4. Bad brake fluid quality, low boiling point, air bubbles during braking. 5. The internal brake of the master cylinder is bad and the pressure is relieved. 6. The used brake fluid and the original brake fluid are not of the same brand and the same type. Chemical reactions occur between the two and corrosive substances are generated. The aprons at the brake master cylinder and the sub-pump are corroded, resulting in a total Poor seal of pump or sub-pump and pressure relief. In the case of the vehicle, it is first necessary to check whether the used brake fluid is the same brand and the same model as the original factory. If not, replace all components of the brake system involving brake fluid according to the manufacturer's requirements, and then add the brake fluid that meets the requirements. Otherwise, the brake system may suddenly malfunction during operation, posing a serious safety hazard. If there is no problem with the brake fluid, check the brake system for leaks and exhaust the brake system thoroughly. After the exhaust can not be eliminated, it is very likely that there is a quality problem in the newly replaced brake master cylinder and the internal pressure relief. It is recommended to replace the brake system spare parts of the original spare parts to ensure the safety of our personal and property.
Describe:
The line strainers should be installed the upstream shutoff valve and the inlet the backflow preventer .The line filters are installed on the pressure line of the hydraulic system to filter out the mechanical impurities mixed in the hydraulic oil and the colloid, leachate, carbon residue, etc., resulting from the chemical changes of the hydraulic oil itself, so as to prevent the valve core from getting stuck. The clogging of slot and damping hole in throttle hole and the breakage of hydraulic components. The filters have good filtering effect and high precision, but it is difficult to clean after clogging, and the filter elements should be replaced.
Characteristics:
The line filters are especially suitable for automatic control systems and servo systems. It can prevent high precision control elements and actuators from being worn out or jammed too early because of pollution, thus reducing the failure and prolonging the service life of the components. The filter adopts imported fiberglass Filter Material, which has the advantages of high filtration precision, strong oil flow ability, small original pressure loss and large amount of sewage.
Product types:
1. LPF series: Low pressure line filters
2. MPF series: Med-pressure line filters
3. HPF series: High pressure line filters
Line Filters Line Filters,Wedge-Shaped Filament Filter,Power Line Filter,Line Emi Filter Henan Sinofiltec Technology Co.,Ltd , http://www.airfilters.pl
Solution for brakes that are not synchronized when using a water brake
1. There is air in the brake system, because the compressibility of the air is large, so the brake feels soft and the effect is not good.