How to do if the sprinkler pump does not absorb water

If the sprinkler does not absorb water, follow the steps below to diagnose quickly:
The first step is to check the switch. First check whether the water pump outlet and outlet switch of the sprinkler pump is turned on. The water pump for the sprinkler is a self-priming pump. When the water is used for the first time, the water should be poured.
The second step is to check the filter. When the sprinkling of the water pump is not smooth, check the front section of the suction pipe for debris blocking the water inlet, and then check the inlet pipe line by stage to see if there is a leakage failure.
The third step is to check the degree of vacuum. The height of the water pump used for ordinary sprinklers should be less than 5 meters. Then check whether the water pump oil seal of the sprinkler is damaged or not. The leakage of the pump shaft will affect the vacuum level and the seal should be replaced. When the sprinkler engine speed is too low to reach the required vacuum, adjust the throttle to make the speed at about 1700 rev / min, the engine speed varies depending on the gearbox.
The fourth step is to check the power take off. Check if the sprinkler power take-off is working, and the power take-off and the drive shaft can cause the water pump to stop working.
The fifth step to listen to abnormal noise. Check to see if the speed of the sprinkler's water pump is normal and pay attention to whether there is any abnormal sound or not and determine if the pump cannot rotate properly due to debris. However, it is important to note that the pump cannot be idling for a long time during the test. Otherwise, the service life of the pump will be shortened due to the high temperature of the pump.
If the water pump of the sprinkler does not discharge water, after the detailed inspection according to the above steps, if the fault can not be eliminated, then check whether the outlet filter or the pump body is blocked due to a long time when the uncleaned water tank is too dirty.
It's also important to develop good habits. The water irrigation should be cleaned regularly. In winter, after using the watering vehicle, the water tank and the water in the pump body must be drained to prevent freezing and cracking of the tank body and the water pump.
Cheng Li Special Purpose Vehicle Co., Ltd. specializes in the production of sprinklers, sewage suction trucks, suction trucks, garbage trucks, road sweeper tankers, aerial lift trucks, dump trucks, coaches, semi-trailers, fire engines, vans Vehicles, refrigerated trucks, tractors, chemical vehicles, powder material vehicles, cement mixers, wreckers, pressure vessels and other eighteen series over 300 models.
Chengli Special Purpose Vehicles Co., Ltd. will continue to uphold the strict and responsible attitude of surviving with quality and ensuring credibility, and will produce more and better special vehicles for our customers.

Batch Type Oil Distillation Plant

The Waste Engine Oil Distillation Plant is used to refine waste engine oil, crude oil and fuel oil after pyrolysis process into diesel grade oil, gasoline or and base oil. The daily capacity of this plant is about 5-6 tons.

 Waste Engine Oil Distillation Plant

Flow-chat of waste engine oi Distillation Plant

Waste Engine Oil Distillation Plant

Advantage of waste engine oi distillation plant

1. Unique and original manufacturing and technology with our own formula of our equipments in China;

2. Unique horizontal design, high oil output with about 90% oil yield and 100% conversion rate, highly effective and profitable;

3. Good quality end product oil as the substitution of standard diesel oil in usage;

Automatic submerged welding technology, ultrasonic nondestructive testing, both manual and the automatic safety devices;

4. Sync gas recycling system: fully burned after recycling and utilization, saving fuel and preventing pollution;

5. National patent, unique heat insulation shell: high efficiency temperature keeping, excellent energy-saving effect;

6. High condensing efficiency condensers with more oil output. Good quality oil, longer lifetime, and easy to clean;

7. National patent water film smoke scrubbers: efficient removal of the acid gas and dust of the smoke, environmental friendly to meet related national standards.

 

Technical Parameter of Waste engine Oil Distillation Plant

NO.

Item

Technical Parameter

1

Suitable Raw Materials

Waste engine oil, Pyrolysis fuel oil, crude oil

2

Structure

Horizontal Type

3

Capacity(24 hours)

3.5-6.5Mt

4

Work Pressure

Normal Pressure

5

Oil Yield

80%-90%

6

Power

18 kw/H

7

Cooling Method

Cycle water

8

Condensers

4 pieces of Vertical condensers

9

Emission Treatment

New DE-sulfurization Smoke Scrubbers

10

Heating Method

Hot Air

11

Type of Installation

With Foundation

12

Noise dB(A)

≤85

13

Dimension of Reactor(mm)

Ф2200×6000

Ф2500×8800

14

Operating Mode

Semi-continuous Operation

15

Main Chamber Weight (MT)

10~13Mt

16

Total Weight(MT)

25~35Mt

17

Installation Space Required

35m*15m

18

End Product

Non-standard diesel oil

19

Manpower

1~2/shift

20

Shipment Requirement

2*40HC=Ф2200×6000

1*40HC+1*40FR=Ф2500×8800

 

Batch Type Oil Distillation Plant

Batch Type Oil Distillation Plant,Batch Distillation Column,Waste Oil To Diesel,Oil Distillation Plant

Shangqiu Jinpeng Industrial Co., Ltd. , http://www.recyclings.nl