Description:
The ignition analyzer can be used to
measure each cylinder speed of the car engine, high voltage ignition coil
ignition voltage and the injection time of each cylinder. It is induction type,
without dismantling any pats, you can test the general distributor type SPW and
ignition coil type COP. It can dynamically display the parameters and display
the maximum and minimum range.
1. Measures RPM
Functions:
Features: Ignition Tester Ignition Tester,Ignition Coil Tester Tool,Ignition Coil Test,Ignition Spark Tester Shenzhen Cartrend Technology Co, Ltd , http://www.cartrendthings.com
Smart pressure sensor is a kind of commonly used sensor, which has certain application in many industries such as intelligent building, water conservancy and hydropower, aerospace, local telephone, shipbuilding and so on. Everyone must also understand the characteristics of smart pressure sensors.
(1) The measurement range and functions have been expanded. Measurements that meet the parameters and various requirements can be achieved.
(2) Sensitivity and measurement accuracy have been improved, weak signal measurements, various corrections and compensations can be performed, and measurement data can also be accessed.
(3) The stability and possibility of measurement are improved, and the measurement is selectively performed without external interference. The intelligent pressure sensor has high performance.
(4) It can self-diagnose, accurately lock the fault site, and quickly identify fault conditions. It can also implement functions that cannot be implemented in hardware.
(5) There are many output formats, digital communication interfaces, and so on.
Smart pressure sensors or pressure sensors are smart sensors that all have detection and information processing capabilities.
2. Measures spark volt
3. Measures spark burn time
4. Advanced microcontroller technology
5. No ground wire connections required
1. Minimum and
Maximum functions (For COP and SPW modes)
It maintains a continuous record of the minimum and maximum readings of the
function currently selected. To display the Minimum and Maximum readings of the
main display, if not already selected press` Secondary Function/Capture` Button
momentarily. To reset the Minimum and Maximum readings, press the `Power
ON/OFF/Reset` button momentarily. These values are also rest when turning to
[0".
2. Spark KVOLT
Calibration function (For Cop mode only)
It requires the user to calibrate the instruments in order to measure spark
KVOLT in coil on plug and coil near plug ignition systems.
This calibration uses the measurement values obtained during the procedure to
find the optimal measuring parameters or a particular type of ignition module,
and compensates for differences in waveform and signal strength.
Once the Ignition Tester has been calibrated on one of the ignition modules of
the engine being diagnosed, all the subsequent measurement of spark KVOLT will
be relative to the calibration value.
1. Capacitive
pick-up
2. Flexible probe
3. Protective rubber holster
4. LCD display
5. Power ON/OFF/RESET button
6. Secondary Function/Capture button
7. Ignition system button
8. Main Function/Calibrate button
9. Engine Cycles button.