Stainless steel submersible submersible sewage pump with anti-clogging hydraulic components designed to greatly improve the dirt through the ability to effectively pass the pump diameter of 5 times the fiber material and the diameter of the pump diameter of about 50% of the solid particles. Now to introduce the structural characteristics of stainless steel submersible sewage pump what. Stainless steel submersible sewage pump structure description WQP series stainless steel submersible sewage pump consists of a motor and a pump. The two are separated by an oil isolation chamber and a mechanical seal assembly. They are mechatronic products. The pump and the pump are of the same shaft (rotor). The length of the pump is short and the structure is compact. Equipped with a variety of protection devices, making the pump run reliably, the main components of the role as follows: Signal Line 1: Equipped with fully water-proof pump control cabinet for all-round protection of the pump, including items such as water leakage, phase failure, short circuit, overheating, motor overload, etc. Motor Stator 8: Class B or Class F insulation. Water Leak Probe 11: This element is installed in the oil chamber. When the mechanical seal is damaged, water enters the oil chamber and the probe sends a signal to protect the pump by the control system. Mechanical seal 13: The use of double-channel series seal, the selection of new hard anti-corrosion tungsten carbide material, with a sealed reliable, wear-resistant, long life and other characteristics. Impeller 17: The impeller adopts single-flow or double-flow structure. It has strong ability to pass large materials and fiber waste to reduce clogging and winding failure. Pump body 15: Used with impeller, making the pump highly efficient. Sealing ring 18: installed in the pump ring mouth, when the impeller due to the operation of the mouth rings wear, replace the seal ring, to ensure the pump to run at optimum efficiency. ã€Print】 ã€Close】